To fully use this screen, you must have the following permissions assigned to your account:
Read Firewall
Read Virtual Data Centers
Write Entity Meta Data
Read Entity Meta Data
You can use the Firewall screen to configure which web traffic can (or cannot) access your virtual machine or server.
Each entry in the table represents a single rule that allows or blocks web traffic from accessing your virtual machine or server. Within a single rule, you can configure several IP addresses or just a single IP address.
You can combine related IP addresses into an IP Group. For example, if you want to block traffic from three separate IP addresses, you do not have to create three separate firewall rules. Instead, you can combine the three separate IP addresses into a single, configurable IP Group. Then, when you create a firewall rule, you can pick the newly created IP Group as your Source. You can use the same practice for Destination IP addresses. For more information, see Create an IP group.
Similar to an IP Group, you can create a Service Group to combine similar port requirements.
In the Firewall Rules screen, each firewall rule entry contains the following information:
Column | Description |
|---|---|
Rule | You can place firewall rules in a specific order as a way to further filter traffic. Traffic will be tested against each firewall rule, starting with the firewall rule in the top position, followed by the next firewall rule. As a result, Armor recommends that generic rules be placed at the top of the table, with more specific rules towards the bottom of the table. For example, if you have two firewall rules, incoming traffic will be tested against the first rule (the rule in the top position). If the traffic passes the first firewall rule, then the traffic will be tested against the second firewall. If the traffic passes the second firewall rule, then the traffic will be allowed to access your site. In another example, if traffic does not pass the first firewall rule (the rule in the top position), then the traffic will be blocked, even without being tested against the second firewall rule. You cannot change the order of a disabled rule. Each page in the Firewall screen only lists 25 rules. If you have more than 25 rules, these additional rules will be placed in another page within the Firewall screen. To learn how to reorder and move these additional rules into a different page, see Reorder a firewall rule. If you are not familiar with how to order firewall rules, Armor recommends that you send a support ticket for assistance. The order of firewall rules is very important to properly filter undesired traffic. To learn how to send a support ticket, see Armor Support. |
Name | This column displays the descriptive name of the firewall rule. |
Action | This column displays if the firewall rule is configured to Allow or Block web traffic to the Destination. |
Source | This column displays the IP Group that contains the Source IP address (or addresses). The Source IP address is the starting point for the web traffic that you want to allow or block. This can be an IP address, an IP address range, or a CIDR. Each Source IP address must be associated with an IP Group. An IP Group can contain one IP address or several IP addresses. |
Destination | This column displays the IP Group that contains the Destination IP address (or addresses). The Destination IP address is the server or virtual machine that you want to protect. This can be an IP address, an IP address range, or a CIDR. Each Destination IP address must be associated with an IP Group. An IP Group can contain one IP address or several IP addresses. |
Services | This column displays the type of protocol for the configured ports in the firewall rule. |
Status | This column displays the status of the firewall rule:
|
Review Supported Services and Sub-Protocols
| Supported services or sub-protocols | List | Notes | Example |
|---|---|---|---|---|
| Services |
|
|
|
| Additional services |
|
|
|
| Sub-protocols |
|
|
|
Troubleshooting
For rules or groups in an Error state, you can click Retry to troubleshoot the issue. You can only click Retry once. If this action does not resolve the issue, then you must contact Support.