Create a Remote Log Source - Cisco ASA

Error rendering macro 'excerpt-include' : No link could be created for 'ESLP:Permissions for Log Relay and Remote Log Collection (snippet)'.

You can use this document to send Cisco Adaptive Secure Appliance (ASA) logs to Armor's Security Information & Event Management (SIEM).

This document only applies to:

Cisco Adaptive Secure Appliance (ASA) 8.X
Cisco Adaptive Secure Appliance (ASA) 9.X

Pre-Deployment Considerations

To create a remote Log Relay, you must already have:

A Log Relay server on your account
- To learn how to add Log Relay to your account, see Obtain Log Relay for Remote Log Collection
Configured the system clock

Update your Cisco ASA device

Log into your Cisco ASA device.
Access the privileged EXEC mode:
```
hostname> enable
```
Access the global configuration mode:
```
hostname# configure terminal
```
Enable logging:
```
hostname(config)# logging enable
```

Configure the global logging settings:

hostname(config)# logging timestamp
hostname(config)# logging trap warning
hostname(config)# logging asdm warning
hostname(config)# logging device-id hostname

Configure logs to be sent to a designated Armor Log Relay device:
```
hostname(config)# logging host <interface> <ipaddress> <protocol/port>
```
- In <interface>, enter the name of the Cisco Adaptive Security Appliance (ASA) interface.
- In <ipaddress>, enter the IP address of the corresponding Armor Log Relay device.
  - To locate your IP address in AMP, in the left-side navigation, click Infrastructure, click Virtual Machines, and then review the Primary IP column for the corresponding virtual machine.
- In <protocol/port>:
  - For UDP, enter udp/10041.
    Armor recommends that you use UDP.
  - For TCP, enter tcp/10041.
    If you use TCP, then the ASA can determine the availability of the status of the syslog server. If the ASA cannot establish a connection to the syslog server to log activity, then by default, the ASA will not allow new connections for transit traffic. Use the following command to allow transit traffic,
    
    hostname(config)# logging permit-hostdown
To ensure that the log messages use the IP address and not the object names, disable the output object name option:
```
hostname(config)# no names
```
Exit the configuration:
```
hostname(config)# exit
```
Save the changes:
```
hostname# write memory
```

Review the logging configuration:

hostname# show run all logging
logging enable
logging timestamp
logging hide username
logging buffer-size 4096
logging asdm-buffer-size 100
logging buffered warnings
logging trap warnings
logging asdm warnings
logging device-id hostname
logging host inside 100.64.0.10 17/5140
logging flash-minimum-free 3076
logging flash-maximum-allocation 1024

If present, logging standby enables logging on a standby unit with failover enabled. As a result, this option causes increases traffic on the syslog server.

Troubleshooting

Verify that logs are formatted correctly, similar to the following example:

May 22 2019 16:11:55 asav-984 : %ASA-4-411004: Interface Management0/0, changed state to administratively down

Pre-Deployment Considerations

Update your Cisco ASA device

Troubleshooting

Was this helpful?

Topics Discussed