Page Comparison

Topics Discussed

You can use this document to send Cisco Integrated Services Router (ISR) logs to Armor's Security Information & Event Management (SIEM).

This document only applies to:

• Cisco Integrated Services Router (ISR) (IOS)

Pre-Deployment Considerations

...

To create a remote Log Relay, you must already have:

• A Log Relay server on your account

  • To learn how to add Log Relay to your account, see Obtain Log Relay for Remote Log Collection

• Configured the system clock

Update Your Cisco ISR Device

...

1. Log into your Cisco ISR device.

2. Access the privileged EXEC mode:

   Code Block
   language bash

...

1. hostname> enable

2. Access the global configuration mode:

   Code Block
   language bash

...

1. hostname# configure terminal

2. Enable logging:

   Code Block
   language bash

...

1. hostname(config)# logging on

2. Configure the global logging settings:

   Code Block
   language bash

...

1. hostname(config)# no logging console hostname(config)# logging trap warning hostname(config)# logging origin-id hostname

2. Configure the logs to be sent to a designated Armor Log Relay device:

   Code Block
   language bash

...

1. hostname(config)# logging source-interface <interface> hostname(config)# logging host <ipaddress> transport <protocol> port <port>

   Note

   In <interface>, enter the name of the Cisco ISR interface, such as GigabitEthernet 1. In <ipaddress>, enter the IP address of the designated Armor Log Relay device. To locate your IP address in AMP, in the left-side navigation, click Infrastructure, click Virtual Machines, and then review the Primary IP column for the corresponding virtual machine. For <protocol> and <port>, For UDP, enter transport udp port 10117. Armor recommends that you use UDP. For TCP, enter transport tcp port 10117.

2. Exit the configuration:

   Code Block
   language bash

...

1. hostname(config)# exit

2. Save the changes:

   Code Block
   language bash

...

1. hostname# write memory

2. Review the logging configuration:

   Code Block
   language bash

...

1. hostname# show run all logging logging enable logging timestamp logging hide username logging buffer-size 4096 logging asdm-buffer-size 100 logging buffered warnings logging trap warnings logging asdm warnings logging device-id hostname logging host inside 100.64.0.10 17/5140 logging flash-minimum-free 3076 logging flash-maximum-allocation 1024

   Note
   If present, logging standby enables logging on a standby unit with failover enabled. As a result, this option causes increases traffic on the syslog server.

May 22 2019 16:11:55 asav-984 : %ASA-4-411004: Interface Management0/0, changed state to administratively down

...

Topics Discussed

...