Page Comparison

You can use this document to add a remote log collector to a Check Point remote device (log source).

Pre-Deployment Considerations

...

1. Log into the Check Point box via Secure Shell (SSH).

   

2. Enter the "expert" command to access Expert mode, then follow the onscreen prompts to enter your credentials:

   

3. Enter the following command to configure the log exporter to send the logs to the log relay:

   Anchor
   step 3a step 3a

   Code Block
   theme Midnight
   cp_log_export add name <exporter name> enabled true target-server <log relay ip address> target-port 10003 protocol tcp format leef read-mode semi-unified

   1. In <exporter name>, insert the name that you wish to use for the log exporter, with no spaces.
      1. For example: Armor_Exporter
   2. In <log relay ip address>, insert the IP address of the log relay box.

   3. An example of the full command is shown below:

      

      Note
      The exporter will not start immediately.

      
      

4. To start the exporter, enter the following command:

   Code Block
   theme Midnight
   cp_log_export restart name <exporter name>

   1. In <exporter name>, insert the name of the exporter that was used in step 3a.

   2. An example of the full command is shown below:

      

5. Navigate to the directory that was created when you created the log exporter.

   Anchor
   step 5c step 5c

   
   

   1. To find this directory, run the following command:

      Code Block
      theme Midnight
      cd /; find . | grep -i <exporter name>

      
      

   2. Replace the LeefFieldsMapping.XML file with the following .xml file: leeffieldmapping.xml.

   3. Navigate to the conf directory, and replace the LeefFormatDefinition.XML file with the following .xml file: LeefFormatDefinition.xml.

   4. An example of the full command is shown below:

      

6. Restart the Check Point Log Exporter by running the following command:

   Code Block
   theme Midnight
   cp_log_export restart name <log_exporter_name>

   1. An example of the full command is shown below:

      

7. In the Check Point web GUI, go to System Management, then System Logging.

   

   1. Select the Send Syslog messages to management server checkbox.
   2. In the Remote System Logging box, add the IP address of the log relay.
   3. Keep Send Logs from Priority Level set to All.

...