Page Comparison

...

...

...

...

...

...

...

...

...

...

You can use this document to send Juniper logs to Armor's Security Information & Event Management (SIEM).

This document only applies to:

• SRX100, SRX110, SRX210, SRX220, SRX240, SRX550, SRX650, vSRX
• Juniper SRX (JUNOS 15.X)
• Juniper SRX (JUNOS 17.X)
• Juniper SRX (JUNOS 18.X)
• Juniper SRX (JUNOS 19.X)

Pre-Deployment Considerations

...

To create a remote Log Relay, you must already have:

• A Log Relay server on your account
  
  • To learn how to add Log Relay to your account, see Obtain Log Relay for Remote Log Collection
• Configured the system clock

Update Your Juniper Device

...

1. Log into the Juniper SRX device.

2. Access the privileged EXEC mode:

   Code Block
   language bash theme Midnight
   user@hostname> configure

3. Configure logging to a designated Armor Log Relay:

   Code Block
   language bash theme Midnight
   [edit] user@hostname(config)# set system syslog host <ipaddress1> <facility> <severity> user@hostname(config)# set system syslog host <ipaddress1> port <port> user@hostname(config)# set system syslog host <ipaddress1> source-address <ipaddress2> user@hostname(config)# set system syslog host <ipaddress1> structured-data

   Note

   In <ipaddress1>, enter the IP address of the designated Armor Log Relay instance. To locate your IP address in AMP, in the left-side navigation, click Infrastructure, click Virtual Machines, and then review the Primary IP column for the corresponding virtual machine. In <ipaddress2>, enter the source IP address on the SRX from where syslog messages will be sent. In <facility>, to filter the type of logs sent to Armor, enter the corresponding facility number, such as 0 for kernel or 4 for authorization. To learn about Juniper's facility numbering system, please review Juniper's documentation. In <severity>, to filter the type of logs sent to Armor, enter the corresponding severity level from 0 to 7. To send all log types, enter 7. To learn about Juniper's severity levels, please review Juniper's documentation. Note If your SRX device is licensed to use the Unified Threat Management (UTM) security feature set, then Armor recommends that you configure the severity setting to capture all relevant UTM log messages, such as web filtering, content filtering, antispam, antivirus, etc. This action may cause non-UTM log messages not to be forward to AMP. Any unwanted log messages can be filtered using the MATCH command, along with the required regular expression syntax. To learn how to filter messages, please review Juniper's documentation. In <port>, enter 10150 for UDP. TCP is not supported.

4. Save the changes:

   Code Block
   language bash theme Midnight
   [edit} user@hostname# commit

5. Review the logging configuration:
   

   Code Block
   language bash theme Midnight
   user@hostname# show system syslog

May 22 2019 16:11:55 asav-984 : %ASA-4-411004: Interface Management0/0, changed state to administratively down

Additional Documentation

Review the following documentation from Juniper:

• SRX Getting Started - Configure Logging
  
• SRX Getting Started - Configure System Logging
• SRX Getting Started - Configure Traffic Logging (Security Policy Logs) for SRX Branch Devices
• Junos OS System Logging Facilities and Message Severity Levels

Was this helpful?

Topics Discussed