Page Comparison

Topics Discussed

In the Firewall screen, each entry in the table represents a single firewall rule; however, each firewall rule can contain several protocols (and ports).

You can combine related protocols (and ports)into a Service Group. For example, if you want to create a firewall rule to block three types of traffic, you do not have to create three separate firewall rules. Instead, you can combine the three types of traffic (protocols and ports) into a single, configurable Service Group. Then, when you create a firewall rule, you can pick the newly created Service Group.

Anchor
Create a service group Create a service group

Create a Service Group

In the Firewall screen, each entry in the table represents a single firewall rule; however, each firewall rule can contain several protocols (and ports).

1. In the Armor Management Portal (AMP), on the left-side navigation, click Security.

2. Click Firewall.

3. If you have virtual machines in various data centers, then in the top drop-down menu, select the desired data center.

4. Click Service Groups.
5. ClickActions, and then clickNew Group.
6. In Service Group Name, enter a descriptive name.
7. In Add Members To Group, enter the service or sub-protocol, and then click the plus ( + ) icon.
   • You must add at least one member.

   • You can add multiple members to a service group.

     Service or sub-protocol	Notes	Example
     Services (TCP, UDP, etc.)	You must enter a port number. These services are not case-sensitive.	tcp/80 TCP/80 Tcp/80 tCp/80
     Additional services (AARP, AH, etc.)	These additional services are not case-sensitive. Do not enter a port number with these additional services.	ATALK igmp Gre
     Sub-protocols (echo-reply, redirect, etc.)	You must enter icmp, followed by the specific sub-protocol. You must enter the sub-protocol in lower-case letters. Do not enter a port number.	icmp/source-host-isolated icmp/time-exceeded

8. Click Apply.
   • The newly created service group will appear at the bottom of the table.

Anchor
Edit a Service Group Edit a Service Group

Edit a Service Group

1. In the Armor Management Portal (AMP), on the left-side navigation, click Security.

2. Click Firewall.

3. If you have virtual machines in various data centers, then in the top drop-down menu, select the desired data center.

4. Click Service Groups.
5. Locate and place your cursor over the desired service group.
6. Click the pencil icon.
7. Make your changes, and then click Appy to save.

Anchor
Delete a Service Group Delete a Service Group

Delete a Service Group

1. In the Armor Management Portal (AMP), on the left-side navigation, click Security.

2. Click Firewall.

3. If you have virtual machines in various data centers, then in the top drop-down menu, select the desired data center.

4. Click Service Groups.
5. Locate and place your cursor over the desired service group.
6. Click the trash icon.

7. Click Delete Service Group.

Was this helpful?